CB77 clutch plate thickness

LOUD MOUSE · Post by **LOUD MOUSE** » Tue Dec 23, 2014 8:32 am

The 5 plate with aluminum plates and was issued in about 1966 and is referred to as a "Cush Drive".
If you can send me picks of the parts of your 5 plate and I'll tell you what you have. ......lm

auntyflossie wrote:I have both 5 Plate and 6 Plate clutches, any advise on which is best?
Thanks Martyn

auntyflossie · Post by **auntyflossie** » Tue Dec 23, 2014 8:50 am

Yes Thanks, that is a good read.
Martyn

auntyflossie · Post by **auntyflossie** » Wed Dec 24, 2014 5:47 am

Here is my Hub.
Thanks Martyn

auntyflossie · Post by **auntyflossie** » Wed Dec 24, 2014 5:49 am

With Plates in

auntyflossie · Post by **auntyflossie** » Wed Dec 24, 2014 5:55 am

If anybody is interested we have a Facebook group for Cb72/77's here https://www.facebook.com/groups/745275825545348/

LOUD MOUSE · Post by **LOUD MOUSE** » Wed Dec 24, 2014 7:06 am

You have a Cush Drive.
I think you can clean it, oil it and use it. ...............lm

auntyflossie wrote:Here is my Hub.
Thanks Martyn

auntyflossie · Post by **auntyflossie** » Sat Dec 27, 2014 2:41 pm

I have just been looking in the parts book for the part number of the clutch springs for my model. There were three numbers given for different springs but none of them were for my engine number
(CB771022169) .
Any Ideas?

honda305.com Forum

honda305.com Forum

CB77 clutch plate thickness