Steverino's CB77

Steverino · Post by **Steverino** » Fri May 08, 2015 5:00 pm

Thank you 48lesco. I appreciate the heads up. This swingarm is going together with all new and nos parts. Swing arm pin included. I would not like to have poor results.
Steve

Steverino · Post by **Steverino** » Fri May 08, 2015 9:11 pm

Like these G Man?
http://www.ebay.com/itm/Qty-8-4-Pair-No ... 64&vxp=mtr

G-Man · Post by **G-Man** » Sat May 09, 2015 12:35 am

Yep, they look perfect.

G

Steverino · Post by **Steverino** » Thu May 14, 2015 12:32 am

Hi Everyone
I've been rueing the day I took the frame to the powder coater without noticing the damaged center stand mounting holes. If I would of noticed the problem beforehand I would of simply welded the holes and drilled new ones. In the aftermath I first planned to save the powder coat by avoiding the heat of welding by drilling the holes out to accommodate a set of bushes. The problem with doing the repair this way was that the holes were so damaged I wouldn't have enough material left to provide a strong mounting point.
Today I decided to weld up the holes and drill new ones.

KIMG0011 by Steve Steverinomeister, on Flickr
My NOS swing arm pin arrived yesterday. It was way too expensive to call it a bolt.

KIMG0002 by Steve Steverinomeister, on Flickr
I am hopeful I can have the bike on two wheels in the next few days.
Steve

alan curtis · Post by **alan curtis** » Thu May 14, 2015 4:16 am

Made a little template for mine. Alan
http://s305.photobucket.com/user/sevenu ... rt=2&o=108

Steverino · Post by **Steverino** » Thu May 14, 2015 9:51 am

Thanks Alan
If it's okay with you I will try to scan your template and use it today.
Steve

Steverino · Post by **Steverino** » Fri May 15, 2015 12:39 pm

Center Stand holes are now repaired. I hope to paint the area tonight and install the swingarm and center stand in the next few days.

15 - 1 (7) by Steve Steverinomeister, on Flickr

Honda305.com Forum

honda305.com Forum

Steverino's CB77

frame