My 1965 CL77

[LOUD MOUSE]

Have you made sure the tubes are not bent?. ............lm

They look great. I have a pair i pulled off a donor bike this morning (cl72) they look solid just a lite surface rust but should clean up good. How do you get them apart?


Separate question ill ad pics to illustrate the point but im having issues with the front forks. is the supposed to be and angle on the top by the clamps. I have 2 pairs of 72 forks all seemingly good condition apart from 1 is a little rusty. all of them have the same angle. when i put them on the front forks separate to the point they have to be pulled in to meet the wheel. Something is definitely not right. None appear damaged and all the bends measure the same. Or is it correct and the forks just need to be swiveled in the clamp so that the angles of both sides match and in theory close the gap (note i haven't tried that)
The later style forks and wheels i used to start with didn't have this issue but all my early forks have the same bend to the milometer


the i rotate the fork 180deg

[thepunisher2007]

the only "bend" is the bit by the clamps but all of the early model forks i have are the same. it made me question if it was meant to be there.

[G-Man]

The forks have many different diameters and taper sections but they should not be bent.

G

the only "bend" is the bit by the clamps but all of the early model forks i have are the same. it made me question if it was meant to be there.

[G-Man]

Take a look at my thread from a few years ago for disassembly.

http://www.honda305.com/forums/dissasem ... 94-28.html

They look great. I have a pair i pulled off a donor bike this morning (cl72) they look solid just a lite surface rust but should clean up good. How do you get them apart?

[thepunisher2007]

i must be really unlucky then :( ill have to see if they can be straightened. Thanks for the info on the rear shocks

[thepunisher2007]

Before

[thepunisher2007]

After