CL Engine covers L7 R

gordonkreltsz · Post by **gordonkreltsz** » Tue May 26, 2015 8:28 am

Hi, On the CL 77 is it better to powder coat the side covers,
or Spray paint it.
Thanks,
Gordon Kreltszheim

bamacl · Post by **bamacl** » Tue May 26, 2015 8:08 pm

Up to you. Powder coat will take a lot more abuse. Easier to find the correct color with paint.

gordonkreltsz · Post by **gordonkreltsz** » Wed May 27, 2015 12:36 am

Hi, Thanks for the advise, Gordon.

Waveblaster · Post by **Waveblaster** » Wed May 27, 2015 1:31 am

I would paint them but that is my preference.

Paint allows to fill imperfections. While the powder coat is durable it is more difficult to repair. A relatively flat area like that I think paint would be preferential.

gordonkreltsz · Post by **gordonkreltsz** » Wed May 27, 2015 7:02 am

Hi, Thanks, I will take your advise & get the covers painted, where could you purchase,& the name of the company, a Left hand engine cover Gasket gear lever side, for a 1965 model CA77 I live in Sydney., Could you form a synthetic, silicone gasket? will it work.
Thanks,
Gordon.

Waveblaster · Post by **Waveblaster** » Wed May 27, 2015 9:15 am

HI Gordon

I am not sure if not fitting the gasket will put pressure on the shaft that supports the oil filter. It would probably work with silicon but I have not tried it and you would need to measure the tolerances.

Davidsilverspares.com have the gasket although it will be more economical long term to buy a full kit . the below site has the full set and shipping is a few days from Japan.

http://www.ebay.com/itm/Honda-CB77-CA77 ... 20f7b35d94

gordonkreltsz · Post by **gordonkreltsz** » Wed May 27, 2015 10:07 pm

Thanks once again, the Gasket kit looks good & cheap, Regards,Gordon.

Honda305.com Forum

honda305.com Forum

CL Engine covers L7 R

CL Engine covers L7 R

Engine covers